Adjusting the Flash Time
3231
Initializing the Phone
(
Base Set / Remote Set
)
1 2 3 4
5
All functions
will be
initialized with
a completion
sound.
All functions will be initialized
with a completion sound.
Press the three buttons at the
same time and hold for at least
3 seconds.
Base Set in
standby mode
Remote Set
in
standby mode
This is to initialize the phone to its original condition.
● Ring type : 1
● Call Restriction : Cancel
● Morning call / alarm time : 06:00
● Ring volume : Medium
● Phone volume : Low
● Recently number : None
● Phone directory : None
● Current time : 24:00
● Dial mode : Pulse
● Flash time : 100ms
● Ring type : 1
● Ring volume : High
● Phone volume : Medium
● Recently number : None
● Phone directory : None
● Date / Time : 01/ 01 24:00
Base Set Remote Set
Default or Initial State
of the Phone
Press button on the top.
Displaying
When there is a lot of noise,
or when the call has a bad
connection, you can use this
function to reduce irrelevant
noise by changing channels.
Noise Reduction
(
Using a Remote Set
)
This prevents a remote set
from being disconnected
from the base set.
1 2
∙
If the noise is not reduced,
press the button several times.
Out of Range warning with the Remote Set
1 2
You will see a on the top
of the screen with a warning sound.
When this occurs, move closer
toward the base set.
When the battery voltage of
the remote set falls below a
certain level, a warning is
given.
Low Voltage Warning in Remote Set
1 2
You will hear a warning sound with
these marks blinking.
When this occurs, immediately
recharge your remote set.
When the remote set gets
too far from the Base set
When there is
a lot of noise
When a battery
needs recharging
You can adjust the flash
time.
Press button
1 2 3 4 5
You will hear a
beep confirming
the completion
of the setting.
Displaying
●
You can select the range of the flash time from 0.1 to 1.0 seconds.
Convenient features
Help Functions Help Functions
�Press button to select
the flash time you want.
: Initialization set
:
Initialization
cancelled