Filter
Top Products
7
ASSEMBLING YOUR KEYSET
• Place the keyset face down on a flat surface.
• Insert notched ends of the support bracket into the channels located in the
upper section of the bottom panel.Push towards the top of the keyset to lock
in.
• Plug the handset cord into the jack marked with the symbol.
• Route the handset cord out the RIGHT side of the keyset as you look at it face
down.
• Plug an eight-conductor ethernet cable, from the wall, into the jack marked
LAN on the back of the keyset.(Connect the ITP keyset to any port on the local
network).
• Plug the power connector, from the power adapter provided,into the power
jack on the back of the keyset.The power adapter is not required if the ITP is
connected to a LAN connection that provides power over the ethernet.The
ITP-5107S supports the power over ethernet feature when it is connected to
a IEEE 802.3af compliant LAN switch or power injector port.
IMPORTANT NOTE:
• To prevent damaging the keyset,only use the Power Adapter that came with
the 5107S keyset.
• This manual assumes that the ITP keysets are connected to a functioning local
IP network.The local IP network must be able to communicate with the MCP
and MGI card in the OfficeServ 100, OfficeServ 500, or in the OfficeServ 7000
Series systems over IP.This is assumed regardless of whether the IP keyset is
on a local or remote network.
5107S_keyset.qxp 5/9/2006 9:56 AM Page 13