Filter
Top Products
Samsung DCS Application Note No 15 - Issue 01 Page 5 of 8
For Further Information Call LSP Communications
Programming
The following MMCs are used with E&M Tieline cards:
MMC Description
304 Keyset - Trunk Use
310 LCR Class of Service
400 Trunk ON/OFF
403 Trunk Toll Class
404 Trunk Name
408 Trunk Music on Hold
416 E&M DID table use
422 Trunk Class of Service
603 Trunk Grouping
710 LCR Digit Table
711 LCR Time Table
712 LCR Route Table
713 LCR Modify Route Table
714 DID Table
Description of MMCs
MMC 416
MMC 416 - Unuse DID Trans
When an E&M Tieline is selected dial tone is heard from the remote end. Digits dialled
are used to access features on the remote system. For example if after selecting the
E&M Tieline the digits 205 are dialled, keyset 205 is called.
MMC 416 - Use DID Trans
If the remote system has Use DID Trans programmed in MMC 416, digits received are
translated using the DID table - MMC 714.
For example:
MMC 714 table has digit 8 corresponding to 205 during the day and 206 during the
night in the remote system. When the E&M Tieline selected and the digit 8 is sent to
the remote site, keyset 205 will be called during the or if the remote system is in Night
Service, 206 will be called. MMC 714 also has the ability to delete digits and show a
name.
Other MMCs
Other MMCs are used as they would be used for PSTN or ISDN trunks