Filter
Top Products
7
PAGE
LINE 1
CHANRGE/
PAGE
LINE 2
Each Line on a Separate Modular Jack
1. Remove the handset hook; turn it upside
down, and put it back in the slot. You need
to do this so the handset doesn’t fall out of
the base.
2. Plug one of the telephone line cords into the
L1 or L2 jack on the back of the unit, wrap the
extra line cord around the cord wrap on the
bottom of the base, and then thread it through
the top of the base plate.
3. Plug the remaining telephone line cord into
the L2 jack on the back of the unit.
4. Connect the power supply adapter to the
POWER 9V DC jack on the back of the unit,
and then thread it through the bottom of base.
5. Reverse the direction of the base plate and
replace it by putting the tabs into the slots on
the top of the unit first, and then by snapping
the bottom tabs into place.
6. Plug the telephone line cord from the L1 or L2
jack into a single line modular jack that you
want to be line 1.
7. Plug the other telephone line cord into the
single line modular jack you want to be line 2.
8. Slip the mounting holes over the wall plate
posts and slide the unit down firmly into
place. (Wall plate not included.)
9. Set the T/P switch to T if you have touch-tone
service or to P (pulse) if you have rotary dial
service.
10. Set the RING switch to ON so the handset
rings for incoming calls.
11. Plug the power supply adapter into an AC
outlet and raise the antenna.
12. Place the handset in the base to charge for 12
hours. The CHARGE/PAGE light comes on. If
you don’t charge the handset battery properly
(for 12 hours) when you first set up the
phone, the battery’s long-term performance
will be compromised.
9
1
2
4
6
7
5
11
12