Filter
Top Products
6
WALL MOUNT INSTALLATION
Two Lines on a Single Modular Jack
1. Remove the handset hook; turn it upside
down, and put it back in the slot. You need
to do this so the handset doesn’t fall out of
the base.
2. Plug the telephone line cord into the L1 or
L2 jack on the back of the unit. Wrap the
extra line cord around the cord wrap on
the bottom of the base and then thread it
through the top of the base plate.
3. Connect the power supply adapter to the
POWER 9V DC jack on the back of the unit.
Then thread it through the bottom of base.
4. Reverse the direction of the base plate and
replace it by putting the tabs into the slots
on the top of the unit first and snapping
the bottom tabs into place.
5. Plug the telephone line cord into the dual
line modular jack.
6. Slip the mounting holes over the wall plate
posts and slide the unit down firmly into
place. (Wall plate not included.)
7. Set the T/P switch to T if you have touch-
tone service or to P (pulse) if you have
rotary dial service.
8. Set the RING switch to ON so the handset
rings for incoming calls.
9. Plug the power supply adapter into an
AC outlet and raise the antenna.
10. Place the handset in the base to charge for
12 hours. The CHARGE/PAGE light comes
on. If you don’t charge the handset battery
properly (for 12 hours) when you first set
up the phone, the battery’s long-term
performance will be compromised.
PAGE
LINE 1
CHANRGE/
PAGE
LINE 2
1
2
3
4
5
9
10