Filter
Top Products
20
TROUBLESHOOTING
We do not expect you to have any problems with your TAD-739, but if you do, try
these suggestions.
If the TAD still does not operate properly, try resetting it (see “Resetting the TAD”) or
take it to your local RadioShack store for assistance.
RESETTING THE TAD
If your TAD stops working properly,
use a straightened paper clip to press
RESET
on the back of the TAD to reset
the answering machine.
Note
: Resetting the TAD erases your
outgoing messages and all stored in-
formation.
Problem Remedy
The incoming message is incom-
plete.
Be sure the memory is not full.
The incoming message is unclear. Be sure
VOLUME
is set to the desired sound
level.
Check all phone line connections.
The TAD does not answer after
two, four, or seven rings.
Be sure the TAD is set to answer calls.
Check all phone line connections.
Be sure the AC adapter is properly connected.
Lo
appears on the display. The backup battery is weak. Replace the bat-
tery (see “Installing a Backup Battery” on
Page 9).
The TAD does not respond to the
remote operation security code.
Make sure the phone you used to dial the TAD
is a touch-tone phone. If it is not, you can use a
pocket tone dialer to remotely operate the TAD.
Re-enter your remote operation security code,
pressing each button for 2 seconds.
Enter the default remote operation security
code (739). The code might have been reset to
its default value due to a power failure.
RESET
43-739.fm Page 20 Friday, August 13, 1999 2:00 PM