Filter
Top Products
20
2. Press
MEMO
. If you are storing a
number in the handset memory,
the BATT LOW indicator flashes.
3. Enter the number and any tone or
pause entries (see “Using Tone
Services on a Pulse Line” on
Page 19 and “Entering a Pause”).
4. Press
MEMO
, then enter a mem-
ory location number (
0
–
9
). The
phone beeps to indicate that the
number is stored.
Note:
If the phone sounds five
quick beeps, you have made an
error and the number was not
stored. Start again from Step 2.
5. For each stored number, write the
person’s or company’s name next
to the appropriate location number
on one of the supplied MEMORY
directory stickers. (Use a pencil in
case you want to change the num-
ber later.) Attach the stickers to
the phone.
To erase a stored number, simply
store a new number in its place. Or,
press
MEMO
twice, then press the
memory location number (
0
–
9
) you
want to clear. The phone sounds a
tone.
Entering a Pause
In some telephone systems, you must
dial an access code (
9
, for example)
and wait for a second dial tone before
you can dial an outside number. You
can store the access code with the
phone number. However, you should
also store a pause after the access
code to allow the outside line time to
connect.
To enter a 2-second pause while stor-
ing a phone number, press
PAUSE
(or
REDIAL/P
on the base). For a longer
pause, press
PAUSE
(or
REDIAL/P
) ad-
ditional times.
43-775.fm Page 20 Friday, August 13, 1999 3:25 PM