Filter
Top Products
16
TELEPHONE OPERATION
Note:
You can use the keypad on ei-
ther the handset or the base to oper-
ate the TAD-1016. To use the features
during a call, however, you must use
the same keypad that you used to
make or answer that call.
MAKING AND
RECEIVING CALLS
Using the Handset
To make or answer a call, lift the hand-
set. Or, if the handset is off the base,
press
TALK
. The BATT LOW indicator
on the handset and the IN USE indica-
tor on the base light.
To end a call, place the handset on the
base or press
TALK
on the handset.
Notes:
• If you press
TALK
to hang up and
the phone does not disconnect,
press
TALK
again while holding
the handset closer to the base or
place the handset on the base.
• You cannot use the handset if
someone is using the TAD at the
base. If you press
TALK
when the
TAD is being used, the handset
beeps 3 times.
Using the Speakerphone
To make or answer a call using the
speakerphone, press
SPEAKER
. The
SPEAKER indicator on the base
lights.
To end a speakerphone call, press
SPEAKER
again. The indicator turns
off.
Note:
You cannot use the speaker-
phone if someone is using the TAD
from the handset. If you press
SPEAK-
ER
when the handset is being used,
the SPEAKER indicator flashes.
Switching Between the
Handset and Speakerphone
To switch from the handset to the
speakerphone at any time during a
call, press
INTERCOM
on the handset
then
INTERCOM
on the base, and then
hang up the handset (place the hand-
set on the base or press
TALK
on the
handset).
43-775.fm Page 16 Friday, August 13, 1999 3:25 PM