Filter
Top Products
24
• If you turn the base’s ringer off,
the TAD does not beep when it re-
ceives new messages. See “Turn-
ing the Base’s Ringer Off/On” on
Page 14.
Press
PLAY/SKIP
on the base, or
press
REMOTE
then
PLAY/2
on the
handset. The TAD announces the
number of messages and whether the
messages are old (already listened to)
or new. Then each new message
plays, followed by the day and time it
was recorded.
When you have both old and new
messages, the TAD first plays back
only new messages. After you have
listened to the new messages, you
can listen to all messages (old then
new) by pressing
PLAY
again.
While playing back the messages, the
display shows the number of the cur-
rent message. For example, if you
have a total of four messages (one
old, three new), pressing
PLAY
dis-
plays
2
(the first new message).
If there are no messages when you
press
PLAY
, five beeps sound and the
TAD announces “You have no mes-
sages.”
Notes:
• If the TAD detects a busy signal or
silence for more than 7 seconds
while recording a message, it
stops recording and releases the
call.
• When you play back messages
using the handset, the message
number does not appear on the
display.
To skip to the next message, press
PLAY/SKIP
(or
SKIP/3
on the handset).
To play the current message again,
press
REPEAT
(or
REPEAT/1
on the
handset).
Note:
If you press
REPEAT
within 2
seconds after a message begins play-
ing, the TAD repeats the previous
message.
43-774.fm Page 24 Friday, August 13, 1999 3:14 PM