Filter
Top Products
22
3. When you finish your message,
press
STOP/7
. The TAD beeps,
plays back the message, then
beeps again.
Note:
If your message is less than 2
seconds, the TAD does not recognize
it as a new message, and plays back
the previous pre-recorded message.
Re-record your message and make
sure it is longer than 2 seconds.
To delete your personal message and
use the pre-recorded messages
again, hold down
OGM REC/8
for about
2 seconds until the TAD beeps. Then,
within 2 seconds, press
STOP/7
.
SETTING THE TAD TO
ANSWER CALLS
To set the TAD to answer calls, press
ANSWER
on the base. The number of
currently recorded messages ap-
pears on the display if you set the
TAD to announce and record, or
A
ap-
pears if you set it to announce only.
You can also turn the TAD on and off
from the handset. Press
REMOTE
so
the BATT LOW indicator lights green.
When the TAD announces the current
outgoing message (either a pre-
recorded message or your personal
message), press
ANSWER/6
.
Notes:
• If the incoming message memory
capacity has less than 5 minutes
left, the TAD announces “Remain-
ing time, xx minute(s)” when you
set the TAD to answer calls.
• If the incoming message memory
capacity is full (40 messages or
less than 1 minute left), the TAD
announces “No remaining time for
incoming messages” and does not
answer calls.
To turn off the TAD, press
ANSWER/6
on the handset or
ANSWER
on the
base.
43-774.fm Page 22 Friday, August 13, 1999 3:14 PM