Filter
Top Products
21
2. Press
SKIP/MEMO
or
REPEAT/
CODE
to set the first digit, then
press
PLAY/STOP
. The TAD beeps,
and the second digit flashes.
3. Press
SKIP/MEMO
or
REPEAT/
CODE
to set the second digit, then
press
PLAY/STOP
. The TAD beeps,
and the third digit flashes.
4. Press
SKIP/MEMO
or
REPEAT/
CODE
to set the third digit, then
press
PLAY/STOP
. The TAD beeps,
and the display shows the number
of messages stored.
To see the new code, press and release
REPEAT/CODE
.
REMOTE ANSWER-ON
Note
: You must record an outgoing
message before you can remotely set
the TAD to answer calls.
Follow these steps to remotely set the
TAD to answer calls.
1. Dial your phone number.
• If the TAD is set to answer-off
and an OGM is recorded, it
answers the call after 60 sec-
onds and announces, “Answer
off.” If no OGM is recorded, the
TAD announces, “Answer off, no
announcement.” Record an
OGM (see “Recording an Outgo-
ing Message”).
• If the TAD is set to answer-on, it
answers after about two or four
rings.
2. Enter the remote operation security
code. The TAD beeps
Note
: If you do not enter each digit
of the security code within 8 sec-
onds, the TAD hangs up.
3. Press
#
.
• If the TAD was set to answer-off,
the TAD announces, “Answer
on.”
• If the TAD was set to answer-on,
the TAD announces, “Answer
off.”
USING REMOTE
COMMANDS
To use remote commands, you must
enter the remote operation security
code. If you do not enter each digit of
the security code within 8 seconds, the
TAD hangs up.
After the TAD beeps once to verify you
entered the code correctly, you can en-
ter the number(s) for the function(s) you
want the TAD to perform.
Note
: The TAD sounds 3 beeps if you
press the wrong button.
43-744.fm Page 21 Friday, August 13, 1999 2:10 PM