Filter
Top Products
16
3. When the service answers, press
TONE
( ). Any additional numbers
you dial are sent as tone signals.
4. After you complete the call, return
the handset to the base or press
TALK
. The phone automatically re-
sets to the pulse mode.
Note:
When you dial a number before
you press
TALK
, you can enter a tone
signal as part of the number (the display
shows ). When you press
TALK
, the
phone automatically adds a 1-second
pause after the tone entry, allowing time
for the service to answer (for example).
PAGING
To send a page from the base to the
handset, when the phone is not in use,
press
PAGE/FIND
on the base. The
handset beeps five times and
PAGING
appears.
To have the handset beep for 1 minute,
hold down
PAGE/FIND
for at least 2 sec-
onds. To stop the handset’s beeping,
press
TALK
twice.
MEMORY DIALING
You can store up to 20 phone numbers
and names in memory, then dial a stored
number by entering a two-digit memory
location number.
Each number can be up to 16 digits, and
each name can be up to 12 characters.
Storing a Number and Name in
Memory
Notes
:
• An error tone sounds and the phone
exits the storing process if you wait
more than 20 seconds between
each key press.
• If you receive a call during memory
entry, the phone exits the storing
process.
1. Lift the handset. If appears,
press
TALK
to turn it off.
2. Press
FUNCTION
.
DIAL
MEMORY?
and
MEM-1
EDIT-0
appear.
3. Press
1
to store a new number.
PHONE
NO.?
appears.
talk
43-1099.fm Page 16 Tuesday, August 17, 1999 4:19 PM