Filter
Top Products
20
If you still have problems, disconnect the phone. If other phones on the same line
work properly, the fault is in this phone or its installation. If you cannot find the prob-
lem, take your ET-919 to your local RadioShack store for assistance.
The phone does not work or works
poorly.
Be sure the base’s phone line cord and
AC adapter are correctly and securely
connected, and the handset’s battery
pack is charged.
The handset stops working or works
poorly during a call.
Move the handset closer to the base.
Be sure the handset’s battery pack is
charged. (If the battery pack power is too
low, it does not have enough power to
light the BATT LOW indicator.)
Lift the base’s antenna to a fully vertical
position.
Make sure the charging contacts on the
handset and base are clean.
If the base lost power while the handset
was off of it, the security access-protec-
tion code might have changed. With the
handset removed from the base, restore
power to the base, then place the hand-
set back on the base. The CHARGE indi-
cator lights, indicating that the code is set
again.
Problem Suggestion
43-1089.fm Page 20 Tuesday, August 17, 1999 3:24 PM