Filter
Top Products
4
2. Press
LINE
1
then lift the handset.
3. Dial one of your phone numbers. If
the Line 2 indicator flashes, the
number is connected to Line 2. If
you hear a busy signal, the number
is connected to Line 1.
After you confirm the phone number for
each line, write the numbers on the
number plate above the keypad. Use a
paper clip to lift off the plate’s plastic
cover. Use a pencil to write the numbers
in case the numbers change.
Setting the Ringer Volume
To adjust the ringer volume, set
RINGER
to
LO
for a quiet ring or
HI
for a louder
ring.
If you do not want the ringer to sound,
set
RINGER
to
OFF
. You can still make
and answer calls if you hear another
phone on the same phone line ring or if
you see a line indicator flashing.
OPERATION
To place a call, press the line button for
an available line and lift the handset.
When you hear a dial tone, dial the num-
ber.
When you receive a call, that line’s indi-
cator flashes. To answer a call, press
the line button (
LINE 1
or
LINE 2
) below
the flashing line indicator and lift the
handset. The line indicator turns off.
The ring for Line 1 has a lower pitch
than the ring for Line 2. This helps you
tell which line is ringing.
To end a call, hang up the handset.
Adjusting the Handset Volume
Set the handset volume switch in the
center of the handset to the desired lev-
el (
LO
,
MED
, or
HI
).
Using Hold
To place a call on hold, press
HOLD
.
The line’s indicator lights.
Line Indicator
43-651.fm Page 4 Friday, August 13, 1999 10:51 AM