Filter
Top Products
10
4. Align the keyhole slots on the
back of the base with the mount-
ing studs on the wall plate, then
carefully push the base onto the
studs and slide it down.
5. Place the handset on the base.
6. Place the base’s antenna in a ver-
tical position.
Mounting the Base
Directly on the Wall
You need two wood screws (not sup-
plied) for this mounting method. Make
sure the heads of the screws fit into the
keyhole slots on the back of the base.
Follow these steps to mount the phone
directly on the wall.
1. Drill two holes 3
1
/
4
inches apart.
Then thread a screw into each
hole, letting the head extend
1
/
8
inch from the wall.
2. Thread the attached modular cord
through the thick strain relief slot
under the base.
3. Thread the supplied AC adapter’s
cord through the thin strain relief
slot under the base.
4. Align the keyhole slots on the
back of the base with the mount-
ing screws and slide the base
downward to secure it.
43-1037.fm Page 10 Tuesday, August 17, 1999 10:05 AM