Filter
Top Products
15
SETTING THE DIALING
MODE
Set
T/P
(Tone/Pulse) on the back of the
base for the type of service you have. If
you are not sure which type you have,
once the battery is fully charged, do this
test.
1. Set
T/P
to
T
.
2. Lift the handset, then press
TALK
and listen for the dial tone.
3. Press any number other than
0
.
Note:
If your phone system requires
that you dial an access code (
9
, for
example) before you dial an outside
number, do not press the access
code either.
If the dial tone stops, you have
touch-tone service. Leave
T/P
set to
T
.
If the dial tone continues, you have
pulse service. Set
T/P
to
P
.
SELECTING THE
LANGUAGE
The ET-521 comes set to display all Call-
er ID messages in English, but if you
want it to display messages in French or
Spanish, follow these steps.
1. Press
SETUP
on the handset.
Lan-
guage
and the currently selected
language appear.
Note
: If you do not press any key
within 15 seconds after the lan-
guage selection display appears,
the ET-521 exits the language se-
lection display without changing the
current selection.
2. To select another language, repeat-
edly press / or #/ until you see
the desired language.
3. Press
SETUP
to store the selected
language.
43-1021.fm Page 15 Tuesday, August 17, 1999 9:14 AM