Filter
Top Products
9
Installation
4. Route the adapter’s cord through the
strain relief slot on the bottom of the
base.
5. Plug the adapter into a standard AC out-
let.
6. Lift the base’s antenna to a vertical posi-
tion.
On a Wall Plate or Wall
1. Insert the two tabs at the top of the nar-
row end of the supplied bracket into the
base’s upper tab slots, then press down
on the bracket’s latches and insert them
into the lower slots.
2. Plug one end of the supplied short mod-
ular cord into the
TEL
LINE
jack on the
back of the base as in “On a Desk Top,
Shelf, or Table,” Step 1.
3. Insert the supplied AC adapter’s barrel
plug into the
DC IN 9V
jack as in “On a
Desk Top, Shelf, or Table,” Step 3.
4. Route the adapter and modular cords
through the grooves on the bracket.
5. Plug the modular cord’s other end into
the wall plate jack, then align the
bracket’s keyhole slots with the wall
plate studs and slide the phone down-
ward to secure it.
6. Plug the adapter into a standard AC out-
let.
7. Press and lift out the handset holder.
Rotate it 180°, then snap it back into
place so it holds the handset.
8. Lift the base’s antenna to a vertical posi-
tion.
Note:
To mount the phone directly on a wall,
you need two screws (not supplied) with
heads that fit into the keyhole slots on the
bottom of the base.
Follow the steps under “On a Wall Plate or
Wall,” then apply these additional instruc-
tions.
1. Drill two holes
3
15
/
16
inches (100
mm) apart. Then
thread a screw
into each hole,
letting the heads
extend about
3
/
16
inch (5 mm) from
the wall.
RING VOL
OFF-LO-HI
RING VOL
OFF-LO-HI
3
15
/
16
Inches
3
/
16
Inch
43-1126.fm Page 9 Thursday, April 27, 2000 11:23 AM