Filter
Top Products
14
Operation
When you receive a call,
Incoming
Call
appears on the display. To answer it, lift the
handset from the base and press
TALK
. If
auto talk is on, just lift the handset from the
base or press any key.
Talk
and the current
volume setting appear on the display.
To end a call, place the handset on the base
or press
TALK
.
Selecting the Channel
The phone has 20 channels. If the call
seems to disconnect for no reason during a
call, press
CH/SELECT
on the handset to se-
lect a different channel.
Scanning
appears
while your phone searches for a clear chan-
nel.
Adjusting the Handset Volume
To adjust the volume of the sound you hear
through the handset during a call, press
VOL/
CID
8
or
9
99
9
until you obtain the desired vol-
ume level.
Volume
Maximum
,
Volume
High
,
Volume
Medium
, or
Volume
Low
appears on the display.
Once you set the volume level, the setting is
maintained even after you hang up the
phone.
Note:
When you press
VOL/CID
8
88
8
while the
volume is maximum or
VOL/CID
9
while the
volume is low, the setting does not change
and an error tone sounds.
USING THE
SPEAKERPHONE
To make or answer a call using the speaker-
phone, press
SPEAKER
. The SPEAKER indi-
cator lights. When you hear a dial tone, dial
the number.
To set the speakerphone’s volume, slide
VOLUME
on the right side of the base.
To end a speakerphone call, press
SPEAKER
again.
Switching Between the Handset
and Speakerphone
To switch to the speakerphone while you are
using the handset, press
SPEAKER
on the
base. When you hear the conversation or
dial tone on the speakerphone, press
TALK
on the handset.
To switch to the handset while you are using
the speakerphone, simply lift the handset off
the base. If the handset is away from the
base, press
TALK
, then press
SPEAKER
.
Using Both the Handset and
Speakerphone
If someone else is using the speakerphone,
press
TALK
on the handset to join the con-
versation.
If someone else is using the handset, press
SPEAKER
on the base to join the conversa-
tion.
During the call, one person can hang up and
another person can continue the call at the
other keypad. Or, both people can hang up
at the same time to end the call.
Note:
If you hear a high-pitched noise from
the base’s speaker, the handset and the
base are too close together.
USING HOLD
Press
HOLD
to put a speakerphone call on
hold. The HOLD indicator lights. While a call
is on hold, you can make an intercom call
(see “Using Page/Intercom” on Page 16) be-
tween the handset and the base without dis-
connecting the call.
43-1126.fm Page 14 Thursday, April 27, 2000 11:23 AM