Filter
Top Products
12
• If the battery pack gets completely
discharged or the base loses power
while the handset is away from it,
the security access-protection code
needs to be reset. To reset the secu-
rity code, place the handset on the
base. If it was the handset that lost
power, leave the handset on the
base to charge the battery pack.
• The supplied battery pack should
last for about a year. When the bat-
tery pack loses its ability to fully
recharge, order a replacement bat-
tery pack from your local
RadioShack store. (See “Replacing
the Battery Pack” on Page 21.
SETTING THE DIALING
MODE
Set
PULSE
•
TONE
on the back of the
base for the type of service you have. If
you are not sure which type you have,
do this test.
1. Set
PULSE
•
TONE
to
TONE
.
2. Lift the handset and listen for a dial
tone.
3. Press any number other than
0
.
Note:
If your phone system requires
that you dial an access code (
9
, for
example) before you dial an outside
number, do not press the access
code either.
If the dial tone stops, you have
touch-tone service. Leave
PULSE
•
TONE
set to
TONE
.
If the dial tone continues, you have
pulse service. Set
PULSE
•
TONE
to
PULSE
.
SETTING THE RINGER
TONE AND VOLUME
You can select one of four different ring-
er tone/volume settings when the phone
is not in use.
1. Lift the handset. If you hear a dial
tone, press
TALK
to turn it off.
2. Press
RINGER
. The phone sounds
the current ringer tone and volume.
43-1053.fm Page 12 Tuesday, August 17, 1999 1:26 PM