Filter
Top Products
Voice Mail Waiting Indicator
18
VOICE MAIL WAITING
INDICATOR
If you subscribe to the voice mail service from your
phone company, the VOICE MAIL indicator on the
handset flashes when you receive a new voice
message. Call the access number to retrieve your
voice mail. Then enter your personal ID to listen to
the message.
The VOICE MAIL indicator also flashes rapidly
when you receive an incoming call, or slowly when
the base is paging the handset.
If the VOICE MAIL indicator stays lit even after you
retrieve your message, press and hold
PAGE on the
base until it stops beeping (about 5 seconds).
USING A HEADSET
You can make or answer calls with hands-free
convenience using an optional headset that has
a
3
/32 –inch (2.5-mm) plug. Your local RadioShack
store carries a variety of headsets.
To connect the headset, gently flip open the rubber
headset jack cover on the side of the handset. Then
insert the headset’s plug into the jack. Use the keys
on the handset to make or answer calls. Ô
When you finish using the headset, disconnect it
from the handset and replace the rubber cover to
protect the jack.
MEMORY DIALING
You have a total of 100 phonebook locations for
memory numbers (including 10 speed dials) and
Caller ID messages in the handset's memory. So,
for example, if the memory is filled with 80
phonebook records, only 20 Caller ID messages
can be stored.
Ô NOTE Ô
• Connecting a headset
disconnects the
handset’s earpiece and
microphone.
• # and $ on the handset
also control the headset’s
volume.
• If you place the handset
on the base to recharge it
while the headset is
connected, be sure the
handset seats properly.
43-3529_3598.fm Page 18 Monday, April 28, 2003 1:38 PM