Filter
Top Products
14
Installation
While holding
PAGE
, return the
handset to the base for about 3
seconds to reset the security
access-protection code.
o
!
• If the base loses power for about
an hour while the handset is away
from it, the security access
protection code might be lost.
Place the handset on the base to
reset the code.
• If the battery pack becomes weak
during a call, the handset beeps
every 3 seconds and
Low Battery
Low BatteryLow Battery
Low Battery
flashes. When this happens, you
cannot make a call until you
recharge the battery pack.
• If the display is blank and the
phone does not work, recharge the
battery pack. (The battery power
might be too low to light the
display.)
• About once a month, fully
discharge the battery by keeping
the handset off the base until
Low
Low Low
Low
Battery
BatteryBattery
Battery
flashes on the display.
Otherwise, the battery pack loses
its ability to fully recharge.
• The handset loses its security
access-protection code if the
battery pack is completely
discharged. Place the handset on
o
WARNING
o
Dispose of the old
battery pack promptly
and properly. Do not
burn or bury it. See
“Battery Safety
Instructions” on Page 9
for additional information
on proper battery
handling.
!
IMPORTANT
!
Be sure the battery pack
is properly connected
before you try to charge
it. The CHARGE/IN USE
indicator lights when the
handset is on the base,
even if the battery pack
is not connected.
43-3906.fm Page 14 Friday, February 14, 2003 10:41 AM