Filter
Top Products
Operation
18
1. When the phone is in the standby
mode, press and hold
CID/MENU. The
Caller ID setting screen appears.
2. Press
VOL key twice to select ¨Area
Code
¨.
3. Press
SELECT. Ô
4. Use the number keys (
0 - 9), or CH/
DELETE
to enter the three-digit area
code.
5. Press
SELECT. A confirmation tone
sounds and the displayed area code is
entered.
6. Press
END or return the handset to the
base unit to complete the setting. The
handset returns to the standby mode.
Choosing the Dialing Mode
Most phone systems use tone dialing which
sends DTMF tones through the phone lines.
However some phone systems still use
pulse dialing such as in rural areas. Ô
The default setting is tone dialing.
Depending on your dialing system, set the
mode as follows:
1. When the phone is in the standby
mode, press and hold
CID/MENU.
2. Press
VOL key three times to select
¨
Dial¨.
3. Press
SELECT to toggle between
¨
Tone¨ and ¨Pulse¨ for each setting.
4. Press
END or return the handset to the
base unit to complete the setting. The
handset returns to the standby mode.
Ô NOTES Ô
Entering Your Area Code
When the area code has
already been stored in
memory, the stored area
code will be displayed. To
change it, use the CH/
DELETE and number keys
to enter the new area code.
Then press SELECT. A
confirmation tone sounds.
To complete the setting,
press END or return the
handset to the base unit.
Choosing the Dialing
Mode
Make sure your battery
pack is fully charged
before choosing the dialing
mode.