Filter
Top Products
Connecting/Charging the Battery
4
1. Press down and slide the battery
compartment cover off.
2. Plug the battery pack’s connector
into the socket in the compartment
(the connector fits only one way),
then place the battery pack in the
compartment.
Handset No.2
appears.
3. Replace the cover.
To charge the battery pack, place the
handset on the charger. The CHARGE
indicator on the charger lights.
Total:0
and HS2 appear on the display while the
handset is charging. Proceed to
“Registering the Handset” on Page 5.
!
Recharge the battery pack when Low
Battery
appears. Ô
About once a month, fully discharge the
battery by keeping the handset off the
base or charger until
Low Battery stays
lit. Otherwise, the battery pack loses its
ability to fully recharge.
If you are not going to use your phone
for an extended period, disconnect the
battery pack. This increases the battery
pack’s usable life.
The supplied battery pack should last
for about a year. If the battery pack
!
IMPORTANT
!
Be sure the battery pack
is properly connected
before you try to charge
it. The CHARGE
indicator lights when the
handset is on the
charger, even if the
battery pack is not
connected.
Ô NOTE Ô
• Using a pencil eraser,
clean the charging
contacts on the
handset and charger
about once a month.
• If the battery pack
becomes weak
during a call, the
handset beeps and
Low Battery appears.
When this happens,
you cannot make a
call until you
recharge the battery
pack.
• Ifthedisplayisblank
and the phone does
not work, recharge
the battery pack.
(The battery power
might be too low to
light the display.)