Filter
Top Products
6
Before using your phone, you must install the battery
pack, and then charge it for about 15-20 hours.
1. Press down and slide the
battery compartment cover off.
2. Plug the battery pack’s
connector into the socket
in the compartment (the
connector ts only one way),
then place the battery pack in
the compartment. MODELS VARY! PLACE HANDSET
ON THE BASE FOR REGISTRATION OR REFER TO
OWNER’S MANUAL appears.
3. Replace the cover.
To charge the battery pack, place the handset on the
charger. The CHARGE indicator on the charging cradle
lights. Proceed to “
Registering the Handset” on page 9.
Important: Be sure the battery pack is properly
connected before you try to charge it. The CHARGE
indicator lights when the handset is on the charger.
Recharge the battery pack when LOW BATTERY appears.
About once a month, use a damp cloth to clean the
charging contacts on the handset.
If the battery pack becomes weak during a call, the
handset beeps and LOW BATTERY appears. When
this happens, you cannot make a call until you
recharge the battery pack.
If the display is blank and the phone does not work,
recharge the battery pack. (The battery power
might be too low to light the display.)
•
•
•
UU01639BZ_1.indd 6 12/18/2006 11:09:38 AM