Filter
Top Products
2
FCC STATEMENT
Your control complies with Part 68 of
FCC Rules
. You must, upon request,
provide the FCC registration number
and the REN to your phone company.
Both numbers appear on the bottom
of the control.
Note:
You must not connect your con-
trol to:
• Coin-operated systems
• Party-line systems
• Most electronic key phone sys-
tems
This device complies with Part 15 of
the
FCC Rules
. Operation is subject to
the following two conditions: (1) This
device may not cause harmful interfer-
ence, and (2) this device must accept
any interference received, including
interference that may cause undesired
operation.
CONNECTING THE
RECORDING CONTROL
Note:
This control connects directly to
a modular telephone line jack. If your
telephone wiring does not have a
modular jack, you can update the wir-
ing yourself or have the phone compa-
ny update the wiring for you.
• RadioShack stores sell jacks and
adapters to convert older wiring
methods to modular wiring.
• The USOC number of the jack to
be installed is RJ11C (or RJ11W
for a wall plate jack).
1. Plug the control’s modular phone
cord into a modular phone jack.
Note:
To connect both a phone
and the control to the same phone
line jack, first plug a modular
duplex jack (such as RadioShack
Cat. No. 279-357) into the phone
jack. Then plug the control and
phone line cords into the duplex
jack.
2. Connect the control’s larger plug
to your recorder’s microphone
jack. Connect the smaller plug to
your recorder’s remote jack.
3. If you are using a tape recorder
that requires four 1.5V batteries
(could be AA, AAA, C, or D), set
the control’s
6V/3V
switch to
6V
. If
you are using a tape recorder that
requires two 1.5V batteries, set
the control’s
6V/3V
switch to
3V
.
SETTING UP THE
RECORDING CONTROL
1. Set the control’s
RECORD/PLAY-
BACK
switch to
RECORD
.
Illustration
43-1236.fm Page 2 Wednesday, August 18, 1999 9:05 AM