Filter
Top Products
RESTORE DEFAULT FUNCTION
The restore default function performs the following operations on the
handset:
• Clear CID log
• Clear Redial buffer
• Clear Phonebook entries
• Set ringer melody to melody 1
• Set ringer volume to 3
• Set receiver volume to 2
• Set flash duration to short
PROCEDURE
1. Remove the batteries from the handset
2. Press and hold button
3. Install the batteries, release button and wait for a ringing signal
4. Press button 5 on the handset and wait untill you hear a click, all
memories are now cleared and defaults are restored
5. Remove again the batteries, wait a couple of seconds and re-install
them again to power up the handset in a normal way.
MAINTENANCE
* Do not clean any part of your telephone with benzene, thinner or
other solvent chemicals - this may cause permanent damage that is
not covered by the guarantee. When necessary, clean it with a
damp cloth.
* Keep your telephone away from hot, humid conditions or strong
sunlight.
* Every effort has been made to ensure the highest standards of
reliability for your PDX-1000 series telephone. However, if
something does go wrong, please do not try to repair it yourself -
consult your supplier.
* Do not use your telephone outdoors in the rain, or handle it with wet
hands - water can damage electrical equipment.
13