Polycom DCE101 Telephone User Manual


 
Charger Options
1725-36027-001_C.doc 43
Dual Charger
Place the handset face forward
into the Dual Charger front slot.
Place a spare Battery Pack in the
rear slot, charging contacts down.
The front slot takes charging
precedence; the Battery Pack in the
rear slot will begin charging when
the handset in the front slot is fully
charged or when the front slot is
empty.
When the handset or Battery Pack
is seated correctly, the corresponding indicator light will come on. A
bright indicator means the Battery Pack is charging, a dim indicator
means the Battery Pack is waiting to charge. The indicator light will
not come on when the handset is incorrectly seated, the slot is empty
or when the Dual Charger has no power applied. If the indicator light
is off or flashing, it means the handset or Battery Pack is incorrectly
seated. Remove the handset or Battery Pack and reinsert. If the LED
continues to blink or starts blinking at any time during the charging
process, it indicates that there is a problem with the Battery Pack that
makes it unusable. Do not continue to charge the Battery Pack.
Dispose of it properly and do not attempt to use it in the handset. Do
not attempt to open or repair a defective Battery Pack. Contact your
service representative for assistance.
The indicator light will turn off when charging is complete. Full
charging is accomplished in approximately two hours for either slot.
Indicator light
Place the SpectraLink 8002 Wireless Telephone into the Desktop
Charger slot facing forward. If the handset is placed correctly, the red
indicator light will come on. The indicator light will not come on
when the slot is empty, when the SpectraLink 8002 Wireless
Telephone is improperly seated, or when the Desktop Charger has no
power applied.