32
XLC3.4
Phone will not hold charge:
• Make sure the charging contacts on the handset and base are free
of dust and dirt. While unplugged, clean the contacts with a soft
cloth.
• Make sure IN USE / CHARGE light on the base is lit when the
handset is in the cradle.
• If necessary, replace the handset battery.
Difculty in placing or receiving calls:
• Move closer to the base and try again.
• Make sure you have selected the correct dialing mode, tone or
pulse.
• Make sure the AC adapter is not plugged into a wall outlet with
other appliances. Disconnect for 5-10 seconds then reconnect.
Place the handset back on the base and reinsert the AC adapter.
• Make sure the handset battery is fully charged.
Your handset screen is displaying “Searching...”:
• Verify that the AC adapter is plugged into the base and into the wall
outlet.
• The handset is out of range or the power to the base is unplugged.
• Move closer to the base.
• Place the handset into the base until the screen returns to standby
mode. It will take approximately 5-10 seconds for the
handset to register to the base.
• Handset may need to be re-registered to the base manually.
Follow instructions on page 28.
TROUBLESHOOTING