Filter
Top Products
16
Using the Handset
6.1.1 Easy registration
1 Insert the unregistered handset into
the base station to automatically
begin registration.
2 Registering… is displayed on the
screen.
• Upon successful registration, a
validation tone is emitted and the
handset number (1 to 8) will be
assigned by the base
automatically.
6.1.2 Manual registration
1 Power on the handset.
2 On the base station, press and hold
a for 3 seconds. A beep sounds to
indicate that the base station is
ready to accept registration. (No
beep sounds on the SE650.)
If no action is taken on the handset
within 90 seconds, the registration
procedure will be aborted. If this
happens, repeat from Step 1.
3 On the handset, press m, scroll n
to Advanced Set and press o
Select.
4 Scroll n to Register and press
o Select.
5 Enter the PIN when prompted and
press o OK to confirm.
Registering… is displayed on the
screen.
• Upon successful registration, a
validation tone is emitted and the
handset number (1 to 8) is
assigned by the base station
automatically.
6.2 Checking the signal strength
When you power on the registered
handset, the display will show the word
“Searching” and the Antenna icon
flashes until the handset locks onto its
subscribed base. Then the display shows
the standby display.
7 Using the Handset
7.1 Make a call
7.1.1 Predialing
Enter the number (maximum 24 digits)
and then press t or l.
7.1.2 Direct dialing
Press t or l and then dial the
number.
7.2 Answer a call
When the phone rings, press t or l.
7.3 End a call
To end a conversation, press h.
Note
01GB01COV.book Page 16 Wednesday, November 19, 2008 5:04 PM