Filter
Top Products
Preparation
9
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Connections
Base unit
When connecting the AC adaptor to the
base unit, a short beep will be heard. If it is
not heard, check the connections.
Charger (KX-TG7102, KX-TG7103, KX-
TG7122, and KX-TG7123 only)
Connect the AC adaptor to the charger and
route the cable as shown. The charger can
be mounted on the wall, if required.
Note:
L Never install telephone wiring during a
lightning storm.
L The AC adaptor must remain connected
at all times. (It is normal for the adaptor to
feel warm during use.)
L The AC adaptor should be connected to a
vertically oriented or floor-mounted AC
outlet. Do not connect the AC adaptor to a
ceiling-mounted AC outlet, as the weight
of the adaptor may cause it to become
disconnected.
L The unit will not work during a power
failure. We therefore recommend you
also connect a corded-type telephone
(without AC adaptor) to the same
telephone line using a T-adaptor. Your
Panasonic sales shop can offer you more
information about connection possibilities.
Location
L For maximum distance and noise-free
operation, place your base unit:
– away from electrical appliances such as
TVs, radios, personal computers or
other phones.
– in a convenient, high and central
location.
Battery
installation/replacement
Important:
L Use only the included rechargeable
batteries noted on page 4, 6.
L When replacing batteries, we recommend
using the Panasonic rechargeable
batteries noted on page 5, 6.
1 Press the notch on the handset cover
firmly and slide it in the direction of the
arrow.
L When replacing batteries, remove the
old batteries positive (S) terminal first.
Use only the included AC
adaptor and telephone
line cord.
(220–240 V, 50 Hz)
To telephone
network
Hook
(220–240 V,
50 Hz)
Screws
25 mm
Hooks
Use only the included AC adaptor.
TG7100-7120E(e).book Page 9 Tuesday, July 4, 2006 3:29 PM