Filter
Top Products
20
Preparing the Answering System
For assistance, please visit http://www.panasonic.com/phonehelp
Caller’s Recording Time
You can select “1 minute”, “2 minutes”,
“3 minutes” or “Greeting only” for the
caller’s recording time. Your phone
default setting is “3 minutes”.
Make sure that the handset is on the
cradle, the AC adaptor is connected
and the SP-PHONE/HEADSET
indicator light is off.
1
Press {FUNCTION/EDIT}.
2
Scroll to “Set answering ?”
by pressing {
4} or {3} and
press {OK} (Yes key).
3
Press {4} or {3} to select
“Recording time ?” and
press {OK} (Yes key).
• The current setting is displayed.
4
Select the recording time by
pressing {
4} or {3}.
• You can also select the recording
time by pressing dialing buttons {1}
(1 minute), {2} (2 minutes), {3}
(3 minutes) or {0} (Greeting only).
5
Press {OK} (Save key).
• A long beep sounds.
• The display will return to step 3. To
exit the programming mode, press
{EXIT} or wait for 60 seconds.
• You can exit the programming mode any
time by pressing {EXIT}.
Screening Calls
While a caller is leaving a message,
you can listen to the call through the
unit’s speaker. Your phone default
setting is ON.
Make sure that the handset is on the
cradle, the AC adaptor is connected
and the SP-PHONE/HEADSET
indicator light is off.
1
Press {FUNCTION/EDIT}.
2
Scroll to “Set answering ?”
by pressing {
4} or {3} and
press {OK} (Yes key).
3
Press {4} or {3} to select
“Call screening ?” and
press {OK} (Yes key).
4
Select “On” or “Off” by pressing
{
4} or {3} and press {OK}
(Save key).
• A long beep sounds.
• The display will return to step 3. To
exit the programming mode, press
{EXIT} or wait for 60 seconds.
Recording time
:
3min.
[OK]=Save
If you select “Greeting only”, the unit will
answer a call with the greeting message,
and then hang up. The unit will not record
any incoming messages.
TS620bk01.book Page 20 Wednesday, May 24, 2006 2:31 PM