Filter
Top Products
Answering System Features
50 For assistance, please call 1-800-211-PANA (7262).
Ring count
You can change the number of times the
phone rings before the unit answers calls.
You can select “2”, “3”, “4” (default), “5”,
“6”, “7”, or “Toll saver”.
“Toll saver”: The unit answers on the
2nd ring when new messages have been
recorded, and on the 4th ring when there
are no new messages. If you call your
phone from outside to listen to new
messages (page 48), you will know that
there are no messages when the phone
rings for the 3rd time. You can then hang
up without being charged for the call.
1 Press {MENU}.
2 Scroll to “Initial setting” by
pressing {V} or {^}, then press {>}.
3 Scroll to “Set answering” by pressing
{V} or {^}, then press {>}.
4 Scroll to “Ring count” by pressing {V}
or {^}, then press {>}.
5 Press {V} or {^} repeatedly to select
the desired setting.
LYou can also select the ring count by
pressing {0} (“Toll saver”), or {2}
to {7}.
6 Press {Save}, then press {OFF}.
Caller’s recording time
You can change the maximum message
recording time allotted to each caller.
“1min”, “2min”, or “3min” (default): Caller
messages are limited to 1 minute to 3
minutes.
“Greeting only”: The unit plays the
greeting message but does not record
caller messages.
1 Press {MENU}.
2 Scroll to “Initial setting” by
pressing {V} or {^}, then press {>}.
3 Scroll to “Set answering” by pressing
{V} or {^}, then press {>}.
4 Scroll to “Recording time” by
pressing {V} or {^}, then press {>}.
5 Press {V} or {^} repeatedly to select
the desired setting.
LYou can also select the recording
time by pressing {1} to {3}, or {0}
(“Greeting only”).
6 Press {Save}, then press {OFF}.
Note:
LIf message memory becomes full, the
unit will automatically switch to the
“Greeting only” mode.
TG5438_5439.book Page 50 Tuesday, January 11, 2005 4:46 PM