Filter
Top Products
:
Programming using the Base Unit (KX-TGP550 only)
33
Programmable settings
You can customize the unit by programming the following features.
To access the features, there are 2 methods:
– scrolling through the display menus (page 33)
– using the direct commands (page 34)
Some of the features can be programmed through the Web user interface (page 40).
L Direct command is the main method used in this User Guide.
Programming by scrolling through the display menus
1
{MENU} (middle soft key)
2 Press {^}, {V}, {<}, or {>} to select the desired main menu. i {SELECT}
3 Press {V} or {^} to select the desired item in sub-menu 1. i {SELECT}
L In some cases, you may need to select from sub-menu 2. i {SELECT}
4 Press {V} or {^} to select the desired setting. i {SAVE}
L This step may vary depending on the feature being programmed.
L To exit the operation, press {EXIT}.
Note:
L See page 34 for the default settings.
L In the following table, ( ) indicates lines you need to select for the settings.
Main menu Sub-menu 1 Sub-menu 2 Page
Line status
m
––10
IP service Network setting DHCP
*1
–
IP settings
*1
–
Embedded web 40
Call features Call forward
(Line 1: 8 max.)
– Unconditional
*1
– Busy
*1
– No answer
*1
36
Do not disturb
*1
(Line 1: 8 max.)
37
Block anonymous
*1
(Line 1: 8 max.)
37
Block Caller ID
*1
(Line 1: 8 max.)
38
Ringer settings
(
Ringer volume –17
Ringer tone (Line 1: 8 max.) –
Interrupt tone ––