Useful Information
57
For assistance, please visit http://www.panasonic.com/help
Liquid damage
Caution:
L To avoid permanent damage, do not use a microwave oven to speed up the drying process.
I cannot connect my headset to
the base unit.
L Confirm that your headset is turned on.
L Only 1 headset can be connected at a time. Change the
connection to your headset (page 48).
L If your headset is already connected to another Bluetooth
device such as your cellular phone, disconnect the headset
from your cellular phone, then perform the connecting
procedure from the base unit.
Some headset enhanced features
are not available.
L The base unit does not support enhanced features such as Last
number redial or Call reject.
An error tone is heard when I try to
program the Bluetooth feature.
L The bluetooth feature cannot be accessed immediately after
connecting the AC adaptor to the base unit. Wait a few seconds
and try again.
L The headset has not connected to the base unit yet even
though you performed the connecting procedure setting. Wait a
few seconds and try again.
“Add new device” is not
displayed on the base unit when I
try to register a headset.
L 2 headsets have already been registered to the base unit. To
register another headset, deregister an unwanted headset
using the base unit (page 49).
I cannot remember the base unit’s
PIN.
L Use the base unit to change your PIN as follows.
1 {MENU} i {#}{6}{1}{9}
2 {*}{7}{0}{0}{0}
3 Enter the new 4-digit PIN. i {OK}
4 Enter the new 4-digit PIN again. i {OK} i {■} (EXIT)
Problem Cause/solution
Liquid or other form of moisture
has entered the handset/
base unit.
L Disconnect the AC adaptor and telephone line cord from the
base unit. Remove the batteries from the handset and leave to
dry for at least 3 days. After the handset/base unit are
completely dry, reconnect the AC adaptor and telephone line
cord. Insert the batteries and charge fully before use. If the unit
does not work properly, contact an authorized service center.
Problem Cause/solution
TG938x(e).book Page 57 Friday, July 3, 2009 10:10 AM