Filter
Top Products
Useful Information
42
For assistance, please visit http://www.panasonic.com/help
Battery recharge
Making/answering calls, intercom
I cannot register a handset
to a base unit.
L The maximum number of handsets (6) is already
registered to the base unit. Cancel unused
handset registrations from the base unit (page 29).
Problem Cause/solution
The handset beeps and/or
3 flashes.
L Battery charge is low. Fully charge the batteries
(page 10).
I fully charged the
batteries, but
– 3 still flashes or
– the operating time
seems to be shorter.
L Clean the battery ends (S, T) and the charge
contacts with a dry cloth and charge again.
L It is time to replace the batteries (page 10).
Problem Cause/solution
w is flashing. L The handset is too far from the base unit. Move
closer.
L The base unit’s AC adaptor is not properly
connected. Reconnect AC adaptor to the base
unit.
L The handset is not registered to the base unit.
Register it (page 29).
Noise is heard, sound cuts
in and out.
L You are using the handset or base unit in an area
with high electrical interference. Re-position the
base unit and use the handset away from sources
of interference.
L Move closer to the base unit.
L If you use a DSL/ADSL service, we recommend
connecting a DSL/ADSL filter between the base
unit and the telephone line jack. Contact your
DSL/ADSL provider for details.
The handset does not ring. L The ringer volume is turned off. Adjust the ringer
volume (page 25).
L Night mode is turned on. Turn it off (page 28).
I cannot make a call. L The dialing mode may be set incorrectly. Change
the setting (page 13).
L The handset is too far from the base unit. Move
closer and try again.
I cannot make long
distance calls.
L Make sure that you have long distance service.
Problem Cause/solution
TG9321(e).book Page 42 Friday, May 28, 2010 4:34 PM