Filter
Top Products
Useful Information
39
For assistance, please visit http://www.panasonic.com/help
Error messages
If the unit detects a problem, one of the following messages is shown on the display.
Display message Cause/solution
Busy L The called unit is in use.
L Other units are in use and the system is busy.
Try again later.
L Privacy mode is on for the call you tried to join
(page 26).
L The handset you are using is too far from the
base unit. Move closer and try again.
L The handset’s registration may have been
canceled. Re-register the handset (page 29).
Call phone company for
your access #
L You have not stored the voice mail access
number. Store the number (page 33).
Check tel line 1
Check tel line 2
L The supplied telephone line cord has not been
connected yet or not connected properly.
Check the connections (page 8).
L If you use the unit as a single-line telephone
only, erase the message as follows:
To erase “Check tel line 1”, press
{MENU}. i {#}{1}{8}{9}
To erase “Check tel line 2”, press
{MENU}. i {#}{1}{9}{0}
When a power failure occurs, the message is
displayed again. Erase again as above.
Failed L Phonebook copy failed (page 21). Confirm the
other unit (the receiver) is in standby mode
and try again.
Incomplete L Phonebook copy is incomplete. The
receiver’s phonebook memory is full. Erase
the unnecessary phonebook entries (page 20)
from the other unit (the receiver) and try
again.
Memory full L The phonebook memory is full. Erase
unnecessary entries (page 20).
TG9321(e).book Page 39 Friday, May 28, 2010 4:34 PM