Filter
Top Products
5 E
nter the desired hour and minute you
wish to end this feature.
6 *: Select “AM” or “PM”.
7 MSAVEN a MOFFN
R When the silent mode is set,
is
d
isplayed.
Base unit
1 MM
ENUN#238
2 MbN: Select the desired setting. a
MSAVEN
R If you select “Off”, press MEXITN to
exit.
3 Enter the desired hour and minute you
wish to start this feature.
4 MAM/PMN: Select “AM” or “PM”. a MOKN
5 Enter the desired hour and minute you
wish to end this feature.
6 MAM/PMN: Select “AM” or “PM”.
7 MSAVEN a MEXITN
R When the silent mode is set,
is
d
isplayed.
Changing the start and end time
Handset / Base unit
1 MM
ENUN#237
2 Continue from step 3 for handset or step
3 for base unit, “Turning silent mode on/
off”, page 44.
Changing the handset name
E
ach handset can be given a customized
name (“Bob”, “Kitchen”, etc.). This is useful
when you make intercom calls between
handsets. You can also select whether or not
the handset name is displayed in standby
mode. The default setting is “No”. If you select
“Yes” without entering any handset name,
“Handset 1” to “Handset 6” is displayed.
Handset
1 MM
ENUN#104
2 E
nter the desired name (max. 10
characters; see the character table,
page 32).
R If not required, go to step 3.
3 MSAVEN
4 MbN: Select the desired setting. a
MSELECTN 2 times
5 MOFFN
Call block (Caller ID subscribers
only)
This feature allows the unit to reject calls when:
– the unit receives a call from a phone
number stored in the call block list as
unwanted (“Storing unwanted callers”,
page 45).
– the unit receives a call without phone
number (“Blocking incoming calls without
phone number”, page 46).
When a call is received, the unit rings for a
short time
*1
while the caller is being identified.
If the phone number matches an entry in the
call block list, the unit emits no sound to the
caller, and disconnects the call.
*1 This is called first ring. If you do not want
the first ring to sound, turn this setting to
“Off” (page 46).
Important:
R When the unit receives a call from a
number that is stored in the call block list or
a call without a recognized phone number,
the call is logged in the caller list
(page 49) with after the call is
d
isconnected.
R You can program this setting using either
the base unit or one of the handsets.
Storing unwanted callers
Y
ou can store up to 250 phone numbers in the
call block list.
Important:
R We recommend storing 10 digits (including
an area code). If only 7 digits are stored, all
numbers that have the same last 7 digits
will be blocked.
n From the caller list:
For assistance, please visit http://www.panasonic.com/help
45
Programming
TG78xx(en)_1210_ver101.pdf 45 2012/12/10 21:19:28