Filter
Top Products
Changing the handset name
Each handset can be given a customised
name (“Bob”, “Kitchen”, etc.). This is useful
when you make intercom calls between
handsets. You can also select whether or not
the handset name is displayed in standby
mode. The default setting is “No”. If you select
“Yes” without entering any handset name,
“Handset 1” to “Handset 6” is displayed.
1 M
N (right soft key) #104
2 Enter the desired name (max. 10
characters; page 33).
R If not required, go to step 3.
3 MOKN
4 MbN: Select the desired setting. a MOKN
2 times
5 MeN
Incoming call barring (Caller ID
subscribers only)
This feature allows the unit to reject calls from
specified phone numbers that you do not want
to answer such as junk calls.
When a call is received, the unit does not ring
while the caller is being identified. If the phone
number matches an entry in the call barred
list, the unit emits no sound to the caller, and
disconnects the call.
Important:
R When the unit receives a call from a
number that is stored in the call barred list,
the call is logged in the caller list
(page 29) with after the call is
disconnected.
Storing unwanted callers
You can store up to 30 phone numbers in the
call barred list.
Important:
R You must store the phone number with an
area code in the call barred list.
n From the caller list:
1 MCN (
)
2 MbN: Select the entry to be barred. a
M
N a M N
3 MbN: “Save CID” a MOKN
4 MbN: “Caller Barred” a MOKN
5 MbN: “Yes” a MOKN a MeN
n By entering phone numbers:
1 M
N (right soft key) #217 a
M
N
2 Enter the phone number (24 digits
max.). a MOKN
R To erase a digit, press MCN.
3 MeN
Viewing/editing/erasing bar call
numbers
1 M
N (right soft key) #217
2 MbN: Select the desired entry.
R To exit, press MeN.
3 To edit a number:
M
N a Edit the phone number. a
MOKN a MeN
To erase a number:
M
N a MbN: “Yes” a MOKN a MeN
Note:
R When editing, press the desired dial key to
add, MCN to erase.
Setting call restriction
You can restrict selected handsets from
dialling certain numbers. You can assign up to
6 phone numbers to be restricted, and select
which handsets are to be restricted. Storing
area codes here prevents the restricted
handsets from dialling any phone number in
that area code.
1 M
N (right soft key) #256
2 Enter the base unit PIN (default: “0000”).
R If you forget your PIN, contact an
authorised service centre.
3 Select the handsets to be restricted by
pressing 1 to 6.
R All handsets registered to the base unit
are displayed.
26
Programming
TG7851TU(en-en)_0718_ver011.pdf 26 2013/07/18 12:00:00