Filter
Top Products
Preparation
8
Base unit
A
Charge contact
B
{x}
(Page)
C
Ringer
Displays
Display icons
Connections
Base unit
When connecting the AC adaptor to the base
unit, a short beep will be heard. If it is not heard,
check the connections.
Charger (KX-TG7102 and KX-TG7103 only)
Connect the AC adaptor to the charger and route
the cable as shown. The charger can be mounted
on the wall, if required.
Bemærk:
L
When connecting the telephone line cord to the
telephone network, use the included telephone
Display
icon
Meaning
w
Within range of a base unit
L
When flashing: Handset is
searching for base unit. (out
of range of base unit,
handset is not registered to
base unit, no power on base
unit)
L
Handset is accessing base
unit. (intercom, paging,
changing base unit settings,
etc.)
k
Handset is on an outside call.
5
Battery strength
[2]
Handset number (Standby
display setting, side 15)
0
New voice mail message
received (side 19) (for Danish
and Swedish users only)
Line is being used by another
handset.
A
B
C
Use only the included AC
adaptor and telephone line
cord.
(220–240 V, 50 Hz)
To telephone
network
Hook
(220
–
240 V,
50 Hz)
Screws
25 mm
Hooks
Use only the included AC adaptor.
TG7100-7102-7103NE(e-da).book Page 8 Wednesday, April 19, 2006 1:09 PM