Filter
Top Products
Special Features
40
Key Tone
You can select whether or not the handset keys will sound tones (key tone,
confirmation tone, error tone). The factory preset is ON.
Re-registering the Handset
If “No link to base. Move closer to base and try again.” is
displayed even when using the handset near the base unit, the handset may have
lost communication with the base unit. You need to re-register the handset to that
base unit.
• Have both the handset and base unit nearby during registration.
• Follow steps 1 and 2 listed below. You have about 1 minute to complete
them.
• If the handset beeps 3 times and “Error!!” is displayed, an error occurred. Try
again from step 1.
• You can stop registration by pressing [OFF] on the handset and pressing
[LOCATOR] on the base unit.
1 Press [MENU].
2 Scroll to “Initial setting” by pressing
[d] or [B], then press the soft key ( ).
3 Scroll to “Key tone” by pressing [d] or [B],
then press the soft key ( ).
4 Select “Off” or “On” by pressing [d] or [B].
5 Press the soft key ( ), then press [OFF].
1 Base unit: Press and hold [LOCATOR] for 3 seconds.
• The CHARGE indicator flashes.
2 Handset: Press and hold [FLASH/CALL
WAIT] until “Handset Registering”
is
displayed
.
• After registration is complete, a long beep
sounds from the handset.
Handset
SELECT
Initial setting
SELECT
Key tone
Key tone
:On
SAVE
Handset & Base Unit
SP
I
PRIVACY
1
Handset
Registering
IN USE
SP
I
PRIVACY
1
Handset [1]
Registered
IN USE