Filter
Top Products
Registering a h
andset to the base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset is
not registered to the base unit, re-register the
handset.
1 Handset:
MMENUN#130
2 Base unit:
Press and hold MLOCATORN for about 5
seconds until the registration tone sounds.
R If all registered handsets start ringing, press
MLOCATORN again to stop, then repeat this
step.
R The next step must be completed within 90
seconds.
3 Handset:
Press MOKN, then wait until a long beep
sounds.
Note:
R While registering, “Base in registering”
is displayed on all registered handsets.
R When you purchase an additional handset, refer
to the additional handset’s installation manual
for registration.
Deregistering a handset
A
handset can cancel its own registration to the
base unit, or other handsets registered to the
same base unit. This allows the handset to end its
wireless connection with the system.
1 MMENUN#131
R All handsets registered to the base unit are
displayed.
2 MbN: Select the handset you want to cancel.
a MSELECTN
3 MbN: “Yes” a MSELECTN
4 MOFFN
For assistance, please visit http://www.panasonic.com/help
27
Programming
TG477x(en-en)_1130_ver021.pdf 27 2011/11/30 15:57:55