Filter
Top Products
Programming
24
For assistance, please visit http://www.panasonic.com/help
4 {r}: Select the desired setting. s
{SELECT} 2 times
5 {OFF}
Call block (Caller ID subscribers
only)
This feature allows the unit to reject calls
when:
– the unit receives a call from a phone
number stored in the call block list as
unwanted (“Storing unwanted callers”, page
24).
– the unit receives a call without phone
number (“Blocking incoming calls without
phone number”, page 24).
When a call is received, the unit rings for a
short time while the caller is being identified. If
the phone number matches an entry in the call
block list, the unit sends out a busy tone to the
caller, and then disconnects the call.
Important:
L When the unit receives a call from a number
that is stored in the call block list or a call
without a recognized phone number, the
call is logged in the caller list (page 27) with
$ after the call is disconnected.
Storing unwanted callers
You can store up to 30 phone numbers in the
call block list.
Important:
L We recommend storing 10 digits (including
an area code). If only 7 digits are stored, all
numbers that have the same last 7 digits will
be blocked.
■ From the caller list:
1 {<} CID
2 {r}: Select the entry to be blocked.
L To edit the number, press {EDIT}
repeatedly until the phone number
is shown in the 10-digit format.
3 {SAVE}
4 {r}: “Call block” s {SELECT}
5 {r}: “Yes” s {SELECT}
6 Edit the phone number if necessary
(24 digits max.).
7 {SAVE} s {OFF}
■ By entering phone numbers:
1 {MENU}(217 s {ADD}
2 Enter the phone number (24 digits
max.).
L To erase a digit, press {CLEAR}.
3 {SAVE} s {OFF}
Blocking incoming calls without
phone number
You can reject a call when no phone number is
provided, such as a call just showing “Out of
area”.
1 {MENU}(24)
2 {r}: Select the desired setting. s
{SAVE} s {OFF}
Viewing/editing/erasing call block
numbers
1 {MENU}(217
2 {r}: Select the desired entry.
L To exit, press {OFF}.
3 To edit a number:
{EDIT} s Edit the phone number. s
{SAVE} s {OFF}
To erase a number:
{ERASE} s {r}: “Yes” s {SELECT}
s {OFF}
Note:
L When editing, press the desired dial key to
add, {CLEAR} to erase.
L When viewing, “Block w/o num” is
displayed if the blocking incoming calls
without phone number feature is turned on.
To turn the feature off: {ERASE} s {V} s
{SAVE} s {OFF}
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to the base
unit.
TG413x(e).book Page 24 Tuesday, December 7, 2010 8:01 AM