Filter
Top Products
Useful Information
24
Caller ID
Liquid damage
Caution:
L To avoid permanent damage, do not use a microwave oven to speed up the drying process.
Registering a handset to the base unit
1 Handset:
{j/OK}
2 {r}: “Settings” s {j/OK}
3 {r}: “Register HS” s {j/OK}
4 Base unit:
Press and hold {x} for about 5 seconds. (No registration tone)
L If all registered handsets start ringing, press {x} again to stop, then repeat this step.
(KX-TG3412)
L The next step must be completed within 90 seconds.
5 Handset:
Press {j/OK}, then wait until a long beep sounds.
L When the handset has been registered successfully, w stops flashing.
Problem Cause/solution
Caller information is not
displayed.
L You must subscribe to Caller ID service. Contact your
service provider/telephone company for details.
L If your unit is connected to any additional telephone
equipment such as a Caller ID box or cordless telephone
line jack, plug the unit directly into the wall jack.
L If you use a DSL/ADSL service, we recommend
connecting a DSL/ADSL filter between the base unit and
the telephone line jack. Contact your DSL/ADSL provider
for details.
L Other telephone equipment may be interfering with this
unit. Disconnect the other equipment and try again.
Caller information is displayed
late.
L Depending on your service provider/telephone company,
the unit may display the caller’s information at the 2nd
ring or later.
L Move closer to the base unit.
Problem Cause/solution
Liquid or other form of moisture
has entered the handset/base
unit.
L Disconnect the AC adaptor and telephone line cord from
the base unit. Remove the batteries from the handset and
leave to dry for at least 3 days. After the handset/base
unit are completely dry, reconnect the AC adaptor and
telephone line cord. Insert the batteries and charge fully
before use. If the unit does not work properly, contact an
authorized service center.
TG341xBX(e).book Page 24 Thursday, March 3, 2011 1:47 PM