Filter
Top Products
Programming
30
Programming using the direct commands
1 {MENU}
2 Enter the desired feature code.
3 Enter the desired setting code.
L This step may vary depending on the
feature being programmed.
4 {Save} i {OFF}
Note:
L In the following table:
– < > shows the default setting.
– If “System setting” column is checked,
you do not need to programme the
same item using another handset (KX-
TG2632).
L If you make a mistake or enter the wrong
code, press {OFF}, then start again by
pressing {MENU}.
Feature Feature
code
Setting code System
setting
Auto talk
*1
{0}{3}{1}: On {0}: <Off>–
Copy phonebook (1 item)
*2
{#}{1} (page 24) –
Copy phonebook (All items)
*2
{#}{2} (page 24) –
Date and time {4} (page 17) r
Dial lock {6} (page 20) r
Interrupt tone
*3
{1}{3}{1}: On {2}: <2> {0}: Off –
Key tone
*4
{0}{2}{1}: <On> {0}: Off –
LCD contrast
(Display contrast)
{0}{1}{1}–{6}: Level 1–6 <3> –
Message alert {0}{#} {1}: On {0}: <Off>–
Message play {2} ––
Recording time {0}{6}{2}{1}: 1min {2}: 2min
{3}: <3min>
{0}: Greeting only
r
Registration {0}{0} (page 40) –
Remote code {0}{6}{3} (page 36) r
Ring count {0}{6}{1}{2}–{7}: 2–7 rings <4>
{0}: Toll saver
r
Ringer tone (Handset) {1}{2}{1}–{3}: Tone <1>–3
{4}–{7}: Melody 1–4
–
TG2631AL_2632AL.book Page 30 Monday, February 20, 2006 2:54 PM