Filter
Top Products
33
Advanced Operation
3
Enter a name, up to 15 characters using
the dialling buttons (p. 34).
•To move the cursor, press BACK Ü or
FWD/EDIT á.
•If a name is not required, press Ö (Next key)
and go to step 5.
4
Press Ö (Next key).
5
Enter a phone number, up to 22 digits.
•Each time you press (CLEAR), a digit is
erased. To erase all digits, press and hold
(CLEAR).
•To move the cursor, press BACK Ü or
FWD/EDIT á.
6
Press Ö (Next key).
•If you want to change the storing name or
number, press Ñ (Edit key) repeatedly to
reach the desired display and change it.
7
Press FWD/EDIT á (Save key).
•A beep sounds.
•
To continue storing other items, repeat from step 2.
•To return to the standby mode, press
(FUNCTION/EXIT/CH).
•If a pause is required for dialling, (REDIAL/PAUSE) can be stored in a phone
number in step 5. This counts as one digit (p. 40).
•You can exit the programming mode any time by pressing (FUNCTION/EXIT/CH).
•If the display shows “Directory full” in step 2, press (FUNCTION/EXIT/CH).
To erase other stored items from the directory, see page 39.
•After the maximum of 50 items has been stored, “Directory full” is also
displayed.
Enter name
Tom Jones
IH G
=Next
Enter name
IH G
=Next
Enter phone no.
0398765432
IH G
=Next
Tom Jones
0398765432
F
=Edit
H
=Save
Tom Jones
0398765432
For New Zealand Users:
Your telephone company may charge you for a local call if the number
dialled has the area code prefix included. If the charge for local call is
unacceptable, only the 7-digits of the local number should be dialled
from your telephone. Do not dial the “0” prefix or the area code digit.