Filter
Top Products
Useful Information
35
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
Error messages
If the unit detects a problem, one of the following messages is shown on the display.
*1 KX-TG2521/KX-TG2522/KX-TG2523/KX-TG2524
*2 KX-TG2522/KX-TG2523/KX-TG2524
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect
the base unit’s AC adaptor and turn off the handset, then reconnect the base unit’s
AC adaptor and turn on the handset.
General use
Display message Cause/solution
Error
*1
L Recording was too short. Try again.
Failed
*2
L Phonebook copy failed (page 19). Confirm the other
handset (the receiver) is in standby mode and try
again.
Incomplete
*2
L The receiver’s phonebook memory is full. Erase the
unnecessary phonebook entries from the other
handset (the receiver) and try again.
Memory Full L The phonebook memory is full. Erase unnecessary
entries (page 18).
Messages Full
*1
L Message memory is full. Erase unnecessary
messages (page 27).
*1
No link to base.
Reconnect AC
adaptor.
L The handset has lost communication with the base
unit. Move closer to the base unit and try again.
L Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
L The handset’s registration may have been cancelled.
Re-register the handset (page 40).
Problem Cause/solution
The handset does not
automatically turn on even after
installing charged batteries.
L Place the handset on the base unit or charger
to turn on the handset.
TG251x_2xE(e).book Page 35 Monday, January 25, 2010 3:09 PM