Filter
Top Products
Base Unit Settings
17
Base unit settings
L Use the handset to customise the base unit.
L When customising the base unit, the current item or setting is indicated by >.
To customise the base unit:
1 {j/OK}
2 Press {^} or {V} to select “Base Unit Setup”. i {>}
3 Press {^} or {V} to select the desired item in the base unit settings menu. i {>}
4 Press {^} or {V} to select the desired item in the sub-menu. i {>}
5 Press {^} or {V} to select the desired setting then press {>} or follow the instruction in the
“Feature” column of the chart.
L To exit the operation, press {ih}.
*1 Change the recall time, if necessary, depending on the requirements of your service
provider/telephone company or PBX.
*2 If you change the PIN, please make note of your new PIN. The unit will not reveal the PIN
to you. If you forget your PIN, consult your nearest Panasonic service centre.
Base unit settings
menu
Sub-menu Feature (default setting)
Ringer Volume — Base unit ringer volume (Medium)
Call Options Recall/Flash Change the recall time (“600 msec.”).
*1
Area Code page 18
Call Restrict page 18
Other Options Base Unit PIN Change base unit PIN (“0000”).
*2
– Enter the current 4-digit base unit PIN.
i Enter the new 4-digit base unit PIN.
i {j/OK}
Repeater Mode (“Off”): page 22
TG1831NZ(e-e).book Page 17 Thursday, June 1, 2006 4:34 PM