Filter
Top Products
Multi-unit Operation
32
5 Wait until “Enter Base PIN” is
displayed, then enter “0000” (default
base unit PIN), then press {j/OK}.
L If you changed the PIN, enter it (page
27).
L When the handset has been
registered successfully, w will stop
flashing. If keytones are turned on
(page 22), a confirmation tone will be
heard.
Cancelling a handset
A maximum of 6 handsets can be registered
to a base unit. A handset can cancel its own
registration (or the registration of another
handset) that is stored in the base unit. This
will allow the base unit to “forget” the
handset.
1 Press {j/OK}.
2 Select “Base Unit Setup”, then
press {>}.
3 Enter “0000” (default base unit PIN).
L If you changed the PIN, enter it (page
27).
4 Enter “335”.
5 Select “Cancel Handset”, then press
{>}.
L The numbers of all handsets
registered to the base unit are
displayed.
6 Select the handset(s) you want to
cancel, by pressing the desired handset
number.
L The selected handset number(s) will
flash.
L To cancel a selected handset number,
press the number again. The number
will stop flashing.
7 Press {j/OK}.
8 Select “Yes”, then press {>}.
9 Press {ih}.
Cancelling a base unit
A handset can cancel a base unit that it is
registered to. This allows the handset to
“forget” the base unit.
1 Press {j/OK}.
2 Select “Handset Setup”, then press
{>}.
3 Select “Registration”, then press
{>}.
4 Enter “335”.
5 Select “Cancel Base”, then press
{>}.
6 Enter “0000” (default handset PIN).
L If you changed the PIN, enter it (page
22).
7 Select “Yes”, then press {>}.
8 Press {ih}.
Note:
L If you cancel the base unit from the
handset’s memory, you cannot use the
handset to make calls or perform other
operations. To use the handset again, you
must first register it to a base unit (page
31).
Increasing the range of the base
unit
You can increase the range of the base unit
by using a DECT repeater. Please use only
the Panasonic DECT repeater noted on
page 4. Consult your Panasonic dealer for
details.
Important:
L Before registering the repeater to this
base unit, you must turn the repeater
mode on.
Turning the repeater mode on/off
1 Press {j/OK}.
2 Select “Base Unit Setup”, then
press {>}.
TG1805AL(e-e).book Page 32 Thursday, March 17, 2005 9:37 AM