Panasonic KX-TD1232E Telephone User Manual


 
12
•*
1
Setting Categories: there are five settings. You must display the destined setting
on this step to select the desired item.
•*
2
If the password has been assigned, it is required only when "SECURITY
SETTING" or "DECT-SYS SETTING" is selected.
•*
3
Selection: the default is in gray.
•*
4
If you set the ringer volume off / vibration on mode or meeting mode using the
UP / DOWN button, the PS doesn't ring regardless of this setting.
•*
5
The display of this item is only displayed when "Automatic Answer Mode Set" is
set to "INT/CO" or "INT ONLY".
Notice
If you set "INT/CO" or "INT ONLY" to the Automatic Answer Mode (PS
Programming) and connect the headset, your phone will answer incoming calls
automatically. If you leave PS unattended with the headset connected, the following
problems will occur.
1. The PS will answer calls and calling party will be charged even though you are
not there to take the call.
2. Depending on the line, even if the calling party disconnects the call, the DECT
line will remain connected until you disconnect the call manually or the battery
expires. The PBX trunk may also remain connected to the network. Please note the
following;
a. Please set "INT/CO" or "INT ONLY" to the Automatic Answer Mode only when
necessary.
b. If you are using the "INT/CO" or "INT ONLY" setting in the Automatic Answer
Mode and you take off the headset, please pull the headset jack out.
The Automatic Answer Mode is not available while the PS is on the charger.
•*
6
If the setting is still "AUTO", the display language will depend on the setting of the
system.
•*
7
The display of this item is displayed only when " " is displayed.
•*
8
This display is used for PS registration and not displayed if all DECT Systems are
registered. For details, consult your dealer.
•*
9
If the displayed language is deleted, the language assigned to "AUTO" will be
displayed.
•*
10
The display of this item is displayed only when the PS is registered.
•*
11
The display of this item is only displayed when more than two fixed terminals are
connected.
•*
12
If "ON" is selected, "ENABLE" of "PS PASSWORD" is selected automatically.
Even if "OFF" is selected, "DISABLE" is not selected automatically.
•*
13
If "DISABLE" is selected, the PS Dialling Directory is unlocked.