Filter
Top Products
Wall Mounting
18
Wall Mounting
• If using a KX-NT305, attach the KX-NT305 (page 17) to the unit first, and
perform step 3 only.
• For information on locking the handset hook, refer to page 13.
1.
Remove the wall mounting adaptor
from the unit as shown, set the
operation board to level 1, then
connect and secure the cables.
• The cables can also be run from
the top of the unit (page 14, 15).
2. Attach the wall mounting adaptor
as shown.
• Make sure the cables are not
pinched by the wall mounting
adaptor. When running the cables
from the top of the unit, look
through the opening in the wall
mounting adaptor
(A) to confirm
that the cables are not being
pinched.
3. Drive the 2 screws (included) into
the wall either 83 mm or 100 mm
apart, and mount the unit on the
wall.
• You can find a wall mounting
template on page 23.
• Make sure that the wall that the
unit will be attached to is strong
enough to support the unit
(approx. 1.5 kg; approx. 2.5 kg
when the KX-NT305 is attached).
• Make sure the cables are securely
fastened to the wall.
• When this product is no longer in
use, make sure to detach it from
the wall.
Slide the wall
mounting adaptor
up to this point.
83 mm
100 mm
Washer
Drive the screw
to this point.
NT300UK_QRG.fm Page 18 Wednesday, May 30, 2007 1:31 AM